Today we are going to learn how to do a projector headlight retrofitting for 1998 to 2002 Honda Accord. Tools you will need with trim pad remover, Phillips screwdriver, drive ratchet, drive extensions, 10mm socket, wire striper and wire crimper. Now, let’s begin to install it.
We can begin by taking off the front bumper, but first let’s remove the two clips. Beneath the front bumper, there are six clips in two 10 millimeter bolts. Remove them with a trim pad remover.
There is a hidden screw where the fenders in the front bumper meets that you need to remove this 10mm screw on both sides. When we’re onto the headlights, each headlight has a bracket below it that you should remove the bracket by taking out three screws. And then take off the headlight assemble.
Once that’s complete go back to the back of the headlights and unplug the harnesses for the light bulbs and the final bolt on top will allow you to pull out the headlights. So that you can unplug the signal light.
Take off your daytime running light bulb and place them in your new bi xenon projector headlights, the daytime running light bulb by pulling out the rubber boot. When all things are done, we can now take the new projector headlights back to its original location.
Put back all the light bulb harnesses and put back all the bolts replace back the front bumper. And put back all the screws and clips to your new Accord projector headlights. When it is ready to light up the street, that need to check all lighting before taking your vehicle out on the road.
Today we are going to learn how to do a projector headlight retrofitting for 1998 to 2002 Honda Accord. Tools you will need with trim pad remover, Phillips screwdriver, drive ratchet, drive extensions, 10mm socket, wire striper and wire crimper. Now, let’s begin to install it.
We can begin by taking off the front bumper, but first let’s remove the two clips. Beneath the front bumper, there are six clips in two 10 millimeter bolts. Remove them with a trim pad remover.
There is a hidden screw where the fenders in the front bumper meets that you need to remove this 10mm screw on both sides. When we’re onto the headlights, each headlight has a bracket below it that you should remove the bracket by taking out three screws. And then take off the headlight assemble.
Once that’s complete go back to the back of the headlights and unplug the harnesses for the light bulbs and the final bolt on top will allow you to pull out the headlights. So that you can unplug the signal light.
Take off your daytime running light bulb and place them in your new bi xenon projector headlights, the daytime running light bulb by pulling out the rubber boot. When all things are done, we can now take the new projector headlights back to its original location.
Put back all the light bulb harnesses and put back all the bolts replace back the front bumper. And put back all the screws and clips to your new Accord projector headlights. When it is ready to light up the street, that need to check all lighting before taking your vehicle out on the road.